Description
Simpson Strong-Tie Zinc Nailon Pin Drive Anchor - 1/4" x 1"
Zinc Nailon anchors are low-cost and easy to install anchors for application under static loads
Features
- Pin and head configuration designed to make anchor tamper-resistant
Material
- Body - Die-cast zamac 3 alloy
- Pin - Carbon Steel; Type 304 stainless steel
Installation
- Drill a hole in base material using a carbide drill bit the same diameter as the nominal diameter of the anchor to be installed. Drill the hole to specified embedment depth, plus 1/4" for pin extension, and blow hole clean using compressed air. Alternatively, drill the hole deep enough to accommodate embedment depth and dust from drilling.
- Position fixture and insert Nailon anchor
- Tap with hammer until flush with fixture, then drive pin until flush with top of head.
**CAUTION**
NOT FOR USE IN OVERHEAD APPLICATIONS
NAILON ANCHORS ARE NOT RECOMMENDED FOR ECCENTRIC TENSION (PRYING) LOADS - CAPACITY WILL BE GREATLY REDUCED IN SUCH APPLICATION
